Punching Heads
Punching heads from Rifast offer a number of advantages:
Click on the links below to display more detail views of the punching head.
Compact
design of stamping head
Simple and
quick set-up, even when die is already set inside the press
Electronic
control of the entire process
Punching
head can be installed in either the upper or lower part of the stamping
die
Installation
possible at any angle
Installation
possible in progressive dies, transfer presses or in robots
Ability to
retrofit into existing dies if an idle station exists
Nuts
- Punching head cross section Studs
- Punching head cross section Punching
head incorporated in upper die Punching
head incorporated in lower die
Punching head inside the stamping die